HOW TO UNCLOG TOILET WHEN NOTHING WORKS

It is easy to panic when you see the water rise towards the edge of the toilet seat when you flush. It is then that in any case I start to think about whether the contents of the toilet can run over the edge, did I really need to use SO much paper and how to unclog toilet when nothing works.

The toilet can actually run over the edge, so do not flush again but do the following instead:

WHAT CAUSES THE BLOCKAGE IN THE DRAIN?

The blockage in the toilet can be due to several reasons: toilet paper, something lying there, cat litter, rinsed napkins, etc. If it is a thing that is in the drain, you may need to dismantle the toilet to access it. If papers have caused the problem, you can increase the pressure and use solvents.

Here are some ways to do this. The different ways are different and certain methods, such as the cleaning belt, risk damaging the toilet. So start with a toilet brush, detergent or sink cleaner.

USE THE TOILET BRUSH

HOW TO UNCLOG TOILET WHEN NOTHING WORKS

Did you use lite too much paper when drying yourself? Then you stand there and watch the water rise towards the edge of the toilet seat. At that moment, it is easy to panic. Will the water overflow? What happens if the water overflows? Will the poop water flow down to the neighbor then? So how to unclog toilet when nothing works.

There is actually a risk that the water flows over the edge. Some toilets are designed to flush a certain predetermined number of liters during each flush. That amount of water is contained in the toilet. But if there is a blockage in the toilet and you flush several times, it can actually run over the edge. So settle for the first flush and do not flush again.

The first thing you can do when you stand there in the toilet and discover that it stops when you flush is to wait a bit and see if it does not sink away by itself. Should the stop remain, you can try using the toilet brush. You actually do not have to reach all the way down to where the stop is with the brush. It can be enough to just create a little movement on the water to make the stop in the toilet to release. The toilet brush may need to be replaced after, but it usually solves most of the stops in the toilet.

Are the children in the toilet when the stop occurred? Then it may be a good idea to check that there are no toys, towels or candlesticks or anything else in the toilet. Disgusting, yes! Is the length of the dish gloves not enough? Then take a garbage bag to thread the arm into. This allows you to lower your arm a little longer to feel so that there are no toys in the toilet and cause the stop. It is actually more common than you think.

Should it not work to wait or to use the toilet brush, there are more ways how to unclog toilet when nothing works.

WASH CLEANER

HOW TO UNCLOG TOILET WHEN NOTHING WORKS

Something that is good to have in the home is the sink cleaner. Should there be a blockage in the toilet, take the sink cleaner and aim at the bend in the toilet, suck on the suction cup and pull it up and down, then release the stopper.

A sink cleaner causes the blockage in the toilet to loosen by using the water pressure. By filling the pump and the toilet with water, the pump creates a water pressure that dissolves the blockage. Make sure that the suction cup closes tightly against the porcelain and then pull the handle. Then run the sink cleaner up and down the toilet.

DETERGENT, CHLORINE AND WATER

HOW TO UNCLOG TOILET WHEN NOTHING WORKS

A very simple method, how to unclog toilet when nothing works is to take water in a bucket and pour it high from the top. Feel free to stand on a chair to remember the fall height of the whole thing. Aim for the bend. When the water is poured high from above, it gets a little more power when it comes down and there is a chance that the stop will dissolve and that the water will drain away.

SEWAGE CLEANER

HOW TO UNCLOG TOILET WHEN NOTHING WORKS

A gadget that perhaps should be in the home is a cleaning tape. A cleaning tape is a steel wire with a spring at the top. You simply push the cleaning belt into the stop. Then you pump back and forth and eventually the stop in the toilet will dissolve. But even here you should be careful not to damage the toilet. Porcelain is quite fragile and a reindeer wire is made of steel. It is easy to damage the porcelain.

CALL A PLUMBER

If none of the above stopped stopping in the toilet, you need to call a plumber. If a blockage in the toilet is a problem you often have, it may be a sign that the pipes may need to be flushed or that a trunk change needs to be made.

A plumber flushes the drains under high pressure, which means that the coatings in the drain pipes are reduced and wastewater will be able to flow better in the future. It may be that the stop in the toilet is actually much further down in the drain pipe. These are the methods to how to unclog toilet when nothing works.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *